DS215UCVAG1A

Description

The DS215UCVAG1A GE Unit Controller 2000/VME Board features one Ethernet connector, and multiple LED status indicators as well as 2 blocks of configuration switches and a connector that enables attachment to a hard disk drive. This board occupies several slots in a VME rack and it enables the operator to control the drive. When using the Ethernet connector, the board can be attached to a local area network (LAN). It is best practice to monitor the placement of the power cables. If the Ethernet cable is too close to the power cables it might pick up interference which would corrupt the Ethernet communications. There are a total of 18 switches that enable the installer or operator to configure the board to process information as required by the site. The printed material that is supplied by the factory provides the information you need to set the switches for the best results. When you receive the board, the switches are in the default settings. The default settings are the common settings used by most applications however you are able to use your fingers to set the switches to work in the best position for your site. There is a reset button in the front panel of the board that is useful in the event the board is experiencing intermittent problems or is experiencing unexplained processing errors. The reset switch restarts the board without powering it down and it enables the board to reload firmware and other instruction code and it is a first troubleshooting step. IC Spares is available to speak with you via phone or email about all of your automation needs. Our staff can provide pricing information for any part or repair.